Assessment Presentation and Submission Guidelines 

Please follow these guidelines when you submit each assignment: 

• Allow a left and right-hand margin of at least 2cm in all assignments. 

• Please type all assignments using 12-point font and 1.5 spacing. 

• All assessments must be submitted through Turnitin in .doc or .pdf format  

• It is the responsibility of the student to ensure that all assessments are successfully submitted through Turnitin. 

• Faculty assignment cover sheets are NOT required. 

 

Draft Submissions & Turnitin Originality Reports 

• Students may use Turnitin’s Originality Report as a learning tool to improve their academic writing if this option is made available in the unit. 

• Students are strongly encouraged to upload a draft copy of each assessment to Turnitin at least one week prior to the due date to obtain an Originality Report. 

• The Originality Report provides students with a similarity index that may indicate if plagiarism has occurred. Students will be able to make amendments to their drafts prior to their final submission on the due date. 

• Generally, one Originality Report is generated every 24 hours up to the due date. 

 

Please note: 

• Students should regularly save a copy of all assignments before submission. 

• Students are responsible for checking that the correct file has been uploaded, that their submission has been successful, and that it has been submitted by the due date and time. 

 

Assignment extensions and late penalties 

• In general, there should be no need for extensions except through illness or misadventure that would be categorised as serious and unavoidable disruption according to the University definition of same, see:  https://students.mq.edu.au/study/my-study-program/special-consideration 

 

• Applications for extensions must be made via AskMQ according to the Special Consideration policy. Extensions can only be granted if they meet the Special Considerations policy and are submitted via https://ask.mq.edu.au/. This will ensure consistency in the consideration of such requests is maintained.  

 

• Students should keep an electronic file of all assessments. Claims regarding "lost" assessments cannot be made if the file cannot be produced. It is also advisable to keep an electronic file of all drafts and the final submission on a USB untouched/unopened after submission. This can be used to demonstrate easily that the assessment has not been amended after the submission date. 

 

• Late Assessment Submission Penalty   

Unless a Special Consideration request has been submitted and approved, a 5% penalty (of the total possible mark) will be applied each day a written assessment is not submitted, up until the 7th day (including weekends). After the 7th day, a mark of ‘0’ (zero) will be awarded even if the assessment is submitted. Submission time for all written assessments is set at 11.55pm. A 1-hour grace period is provided to students who experience a technical issue.     

 

This late penalty will apply to non-timed sensitive assessment (incl essays, reports, posters, portfolios, journals, recordings, etc.). Late submission of time sensitive tasks (such as tests/exams, performance assessments/presentations, scheduled practical assessments/labs, etc.) will only be addressed by the unit convenor in a Special Consideration application. Special Consideration outcome may result in a new question or topic.  

University policy on grading 

Criteria for awarding grades for assessment tasks 

Assignments will be awarded grades ranging from HD to F according to guidelines set out in the University's Grading Policy. The following descriptive criteria are included for your information. 

 

Descriptive Criteria for awarding grades in the unit 

In order to meet the unit outcomes and successfully pass this unit, students must make a genuine attempt at all assessment tasks. Where any submitted assessment task is considered to be unsatisfactory in this regard, the highest possible final grade that can be awarded for the unit will be 45. 

 

Students will be awarded grades ranging from HD to F according to guidelines set out in the policy: https://staff.mq.edu.au/work/strategy-planning-and-governance/university-policies-and-procedures/policies/assessment-in-effect-from-session-2-2016 

 

The following generic grade descriptors provide university-wide standards for awarding final grades. 

  

Grade	Descriptor
HD  (High Distinction)	Provides consistent evidence of deep and critical understanding in relation to the learning outcomes. There is substantial originality and insight in identifying, generating and communicating competing arguments, perspectives or problem-solving approaches; critical evaluation of problems, their solutions and their implications; creativity in application as appropriate to the discipline.
D  (Distinction)	Provides evidence of integration and evaluation of critical ideas, principles and theories, distinctive insight and ability in applying relevant skills and concepts in relation to learning outcomes. There is demonstration of frequent originality in defining and analysing issues or problems and providing solutions; and the use of means of communication appropriate to the discipline and the audience.
Cr  (Credit)	Provides evidence of learning that goes beyond replication of content knowledge or skills relevant to the learning outcomes. There is demonstration of substantial understanding of fundamental concepts in the field of study and the ability to apply these concepts in a variety of contexts; convincing argumentation with appropriate coherent justification; communication of ideas fluently and clearly in terms of the conventions of the discipline.
P  (Pass).	Provides sufficient evidence of the achievement of learning outcomes. There is demonstration of understanding and application of fundamental concepts of the field of study; routine argumentation with acceptable justification; communication of information and ideas adequately in terms of the conventions of the discipline. The learning attainment is considered satisfactory or adequate or competent or capable in relation to the specified outcomes
F  (Fail)	Does not provide evidence of attainment of learning outcomes. There is missing or partial or superficial or faulty understanding and application of the fundamental concepts in the field of study; missing, undeveloped, inappropriate or confusing argumentation; incomplete, confusing or lacking communication of ideas in ways that give little attention to the conventions of the discipline.

 

Note: If you fail a unit with a professional experience component, the fail grade will be on your transcript irrespective of the timing of the placement. 

 

Withdrawing from this unit 

If you are considering withdrawing from this unit, please seek academic advice via https://ask.mq.edu.au before doing so as this unit may be a co-requisite or prerequisite for units in the following sessions and may impact on your progression through the degree. 

 

Results 

Results shown in iLearn, or released directly by your Unit Convenor, are not confirmed as they are subject to final approval by the University. Once approved, final results will be sent to your student email address and will be made available in eStudent. For more information visit ask.mq.edu.au. 

 

Recommended text: 

Smith, S. & Conti, G. (2016). The Language Teacher Toolkit. CreateSpace Independent. ISBN 1523214821, 9781523214822 

 

Information about the unit iLearn site   

This unit has a full web presence through iLearn.   

Students will need regular access to a computer and the Internet to complete this unit.  

Weekly access to iLearn is compulsory for all students. Important assessment information will be posted here, as will other relevant unit notices and materials, including a reading template and guide to lecture note taking to assist your studies. 

Various activities and materials for discussion and critical reflection are included and external students especially are encouraged to use this web component. Electronic links and suggested references will be included in the Resources section. Please check the iLearn unit regularly.  

Weekly lectures are available on the web through the ECHO360 lecture component. You must listen to all lectures if you do not attend these ‘live’. 

PowerPoint slides are available in iLearn in advance of the weekly lecture and/or are available in the Active Learning Tool.  

Access and technical assistance  

Information for students about access to the online component of this unit is available at https://ilearn.mq.edu.au/login/index.php. You will need to enter your student username and password. 

Please do NOT contact the Unit Convenor regarding iLearn technical help.  

No extensions will be given for any technical issues. Allow enough time for your submissions.  

Assistance is available from IT Helpdesk ph: 1800 67 4357 or log a request at help.mq.edu.au. OneHelp is the online IT support service for both students and staff. 

 

This unit requires students to use several ICT and software skills: 

• Internet access: The iLearn site contains materials for this unit; it is also required for the online submission of all Assessment Tasks, and for the use of Turnitin submission for ALL tasks.   

• Word processing, visual representations, and document formatting: You are required to use an appropriate form of software to present your assignments.  

• Uploading of assessment tasks to iLearn. 

 

Other useful information about how the teaching is structured. Suggested wording below. Please amend for your unit. 

 

Structure 

The unit structure can be found in the university timetable https://timetables.mq.edu.au/ 

In the tutorial students will discuss issues and questions arising from the lectures and prescribed readings. They are expected to base their arguments/discussions on evidence from published research and other relevant material. There will be a supporting website for the unit providing additional readings, links and materials. Lectures will also be available through Echo in iLearn from the following website link: http://ilearn.mq.edu.au  

 

Students are required to participate in small group activities, whole class discussion, to read the weekly material in advance, and to complete brief tasks either as individuals or in pairs. The weekly program for the course with the accompanying readings/ preparation is available on the iLearn site. 

Please refer to iLearn for details. 

The 5Rs Framework, developed by the School of Education at Macquarie University, is embedded throughout your teacher education course.

Your use of the 5Rs Framework will help you develop the capabilities that will make your teaching career sustainable and fulfilling.

In this unit, you will learn using the 5Rs framework in the following important ways:

Reflexive:

As part of this unit, you will craft an intercultural autobiographical narrative to reflect on your teacher role, future work in schools, and pedagogical choices in school settings.

Responsive:

Assessment Task 2 will support you to design a learning sequence that caters for the learning of students.

Ready to learn:

Tutorial activities and readings will help you to understand the factors shaping quality Language teaching and consider how your discipline knowledge can be applied to teaching a range of topics and skills.

Research engaged:

The unit readings will give you the opportunity to engage with and evaluate research relevant to your teaching and plan research-informed strategies for engaging students in their work. You will use this research to support your perspectives and explore your current and future teaching.

Resilience: 

Activities in this unit focus on sustainable, high quality approaches to planning and assessing student work.